Tips of Replacing a Fence on your Own

You may notice that your fence is sagging or has gotten so dry that it is exposing your compound. The fence can break down completely without you noticing, if you are keen enough. At times, the details of the fence are the reason the fence loses its integrity. Here the factors that you should consider when replacing your fence.

First, you need to be aware about the local zoning laws. The authorities will have to approve construction of certain structures. Whether or not you are going build the fence over the old one, you still need a permit. You don’t want to be fined for constructing a structure without acquiring a permit first. The new fence needs to meet the set guidelines for it to stand. If the new fence fails to meet the standard requirements, it will either be destroyed or you get fined for that. You should also check with your utility provider even if you intend to build the fence on the same spot. This will help you to identify the points where lines pass through, so that you don’t interfere with them during the construction.

The materials to be used in the construction of the new fence ought to be looked at as well. You should have in mind the duration you want the fence to last. Before you buy the building materials, it is important for you to also consider your budget. You need to buy wood of higher grade so that the fence can last a lot longer. These high quality wood materials will cost a lot more, but if the money is enough, you can entirely replace the wood materials with those made of aluminum vinyl. All the remains of the old fence must be removed from the site so that you can get the space to dig deeper for the posts. The materials required in the building of a sturdy fence ought to be very strong. And the foundation has to be firm as well.

Finally, you need to map out the layout of your new fence. You should identify corner points as well as positions where you will be putting posts throughout the entire fence. You can make those marks with the use of batters and strings. Digging of holes should then follow using a digging bar and shovel. Instead of wasting your energy and time to dig several holes, you can use power augers if the compound is too large. Once you are done digging the holes to the size accepted in the code, you should then set the posts and rails in that order.